-
VolanterRC FPVraptor V2 Tower UAV Trim Scheme 2M Unibody Pusher (757-V2) Eelctric RC Glider Kit Version
$159.00
$109.97 -
P-51D Mustang Yellow 750mm/30.00in EPO Electric RC Airplane PNP
$189.00
$109.99 -
Sopwith Camel 1.2m RC Airplane Pre-Built Balsa ARF
$390.00
$251.97 -
Dynam T-28 Trojan 1270mm EPO RC Plane With Retracts Ready-To-Fly
$399.00
$319.97 -
DW 61" Fokker DR1 Triplane Laser Cut Balsawood RC Airplane Model Kit
$506.00
$259.97 -
VolantexRC Tumbler Auto-roll-back Pool Racer RC Boat (796-1) Ready-To-Run
$139.00
$59.97 -
F-18 Hornet V2 64mm EDF Jet RC Plane PNP
$336.00
$189.92 -
F4U Corsair Blue 750mm/30.00in EPO Electric RC Airplane PNP
$189.00
$108.97 -
Fi156 Storch 1.6M Pre-Built ARF Balsa Electric RC Plane
$500.00
$315.92 -
S.E.5A SE5a 1.62M(63.8")Balsa Wood Pre-Built ARF RC Airplane
$529.00
$321.95
Product Description
5
x 41G Tower Pro SG5010 Ballraced RC Servo
- Output torque is rated at 8kg/cm at 4.8V or 11kg/cm at 6V.
- 100% Brand New Nylon Gear Servo
- Compliant with most standard receiver connector: Futaba, Hitec, Sanwa, GWS etc.
- Each servo comes with servo horns and fittings
- Light Weight
- Less Noise
- Dimension : 40mm x 19mm x 43mm
- Weight : 39g
- Operating Speed :
0.14sec / 60 degrees (4.8V no load)
0.11sec / 60 degrees (6.0V no load) - Stall Torque :
8kg/cm at 4.8V
11kg/cm at 6V - Temperature Range : -30 to 60 Degree C
- Dead Band Width : 4ms
- Operation Voltage : 3.5 - 8.4 Volts
- Motor Type: 3 Pole Ferrite
- Potentiometer Drive: Indirect Drive
- Bearing Type: Dual Ball Bearing
- Gear Type : All Nylon Gear
- Connector Wire Length: 11.81 inch (300mm)